Biscuit Selection
Always try to use the largest biscuit that will fit. In most cases this will be # 20.
Sometimes, especially when building thin frames you will need to scale down to #
10 or #0 biscuit.
The 3 most common biscuit sizes are:
•
# 0 = 16mm Wide x 44mm Long
•
# 10 = 19mm Wide x 54mm Long
•
# 20 = 25mm Wide x 60mm Long
The above mention biscuits are 3.75mm thick and mostly made from compressed
beech wood shavings stamped out in an oval pattern. The glue soaks into the
biscuit causing it to swell and tighten up in the joint.
•
Keep the ventilation slots of the biscuit joiner clean at all times and prevent any
foreign matter from entering.
•
If the housing of the biscuit joiner requires cleaning do not use solvents but a
moist soft cloth only.
•
The grease in the gearbox will require replacement / replenishment after
extensive use of the biscuit joiner. Please see your authorised service agent to
provide this service.
•
Brushes should be replaced before they wear out. Both brushes should be
replaced at the same time.
•
Blow out the unit through the rear ventilation slots with compressed air
periodically to ensure a dust free area around the switch.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by
repair of the biscuit joiner by an unauthorised person or by mishandling.
TIPS FOR USING YOUR BISCUIT JOINER (cont.)
13
MAINTENANCE
