![background image](http://html.mh-extra.com/html/ozito/abk-pro/abk-pro_instruction-manual_1666495003.webp)
2. ASSEMBLY cont.
OPERATION
3. PREPARATION
The paint pot has a vent hole
to allow air to escape which
enables fluid to flow into the
airbrush.
Ensure it is clean and not
blocked.
1 Wrap the threaded male air
inlet of the airbrush and the
connection adaptor with
teflon tape in a clockwise
direction.
5 Connect to the air compressor by pull back the sleeve on air
compressor hose fitting, insert the male plug & release sleeve
on air compressor hose fitting.
1 Before mixing any paint
or thinners work out how
much of each substance is
needed.
3 Squeeze the end of
the dropper to drop the
material into a mixing pot.
Repeat this process for the
remaining paint or reducer.
The airbrush kit comes with a dropper to help measure the
paint and reducer mixtures to obtain the desired colour or
viscocity.
follow the manufacturers guide for thinning and mixing
ratios which should be labelled on the paint container.
2 Squeeze the end of the
dropper and insert into the
material container. Release
the pressure on the end to
suck the required amount
into the dropper.
Paint Pot Vent Hole
Attaching to an Air Compressor
mixing and thinning
NOtE:
fOR BESt RESUltS, SURfACE PREPARAtION ANd PAINt
tHINNING ARE tHE tWO mOSt ImPORtANt AREAS. ENSURE
All SURfACES ARE fREE Of dUSt, dIRt ANd GREASE.
ImPORtANt!
tHE AIRBRUSH CANNOt BE USEd WItH
mAtERIAlS CONtAINING ABRASIVE SUBStANCES, GlAZES,
CAUStIC OR AlKAlINE SUBStANCES.
PAINT
REDUCER
2 Screw one of the air hose
ends onto the male air inlet
of the airbrush.
3 Screw the other end of
the air hose onto the
connection adaptor.
4 You can now screw a male
plug air fitting into the
connection adaptor.
To connect to an air compressor, you will need to have a 1/4”
BSP male plug in your air fitting style of choice (nitto, ryco,
jamec, etc.). The connection adaptor included with this kit
enables you to connect 1/4”BSP fittings to the 1/8” air hose.