ASSEMBLY INSTRUCTIONS
MODEL NO
W804, 10’ x 5’6”
4P Connectent for Canopy
IMPORTANT:
WE ADVISE YOU TO ASSEMBLE THE TENT ONCE BEFORE
GOING CAMPING TO BECOME FAMILIAR WITH THE ASSEMBLY OF THE TENT.
NOTE:
PLEASE LOOK AT THE REPLACEMENT PARTS DIAGRAM TO SEE HOW
YOUR FRAME IS ASSEMBLED.
TO PROLONG THE LIFE OF THE TENT FLOOR, SELECT A LEVEL, CLEAN AREA
FOR THE CAMPSITE. TO PREVENT DAMAGE TO THE ZIPPER, UNZIP THE
DOOR TO ALLOW AIR TO ENTER THE TENT.
TO IMPROVE THE WEATHER RESISTANCE OF YOUR TENT, IT IS ADVISABLE
TO USE SEAM SEALER TO COAT ALL EXPOSED SEAMS. YOU SHOULD APPLY
ONLY TO THE UNDERSIDE OF THE FLY AND INSIDE SEAMS OF THE TENT.
IF APPLIED TO THE OUTSIDE SEAMS, DISCOLORATION OF YOUR TENT
MAY OCCUR. SEAM SEALER IS AVAILABLE IN THE CAMPING SECTION OF
ANY LOCAL SPORTING GOODS STORE.
STEP 1:
Set up your 10’ x 10’ canopy following the directions that came with
the canopy. Make sure it is staked to the ground.
STEP 4:
Starting at the peak of the tent attach the clips on the roof of the tent to
the 2 poles that are on the front side of the canopy.
STEP 5:
Locate the two “S” hooks on the elastic cords
that are located at the upper eave corners at the back of
the tent. Connect the “S” hooks to the eyelets in the back
upper corners of the canopy.
STEP 7:
There are “S” hooks located at the bottom
corners of the tent. These should be connected to the
holes in the bottom of the canopy legs.
STEP 8:
Once the tent is attached to the canopy frame, raise the canopy to
its full height.
STEP 9:
Stake down the front two corners of the tent as
well as the two intermediate points along the front and
back walls of the tent. Hammer the stakes into the ground
at a 45° angle using a hammer or mallet, making sure to
pull tent floor out even and snug.
The assembled tent should
appear as shown.
STEP 3:
Spread the tent out flat under the canopy, floor side down and unzip
the door.
NOTE:
To take down tent, follow steps above in the reverse order. Be sure to
leave door and windows unzipped.
MAKE SURE TENT IS CLEAN AND DRY
BEFORE STORING
. Place stakes into stake bag which is provided. The tent
should be folded into equal parts toward the center of the tent to distribute the
bulk. Start a small tight roll, the width of the carry bag. Roll the tent towards the
door to allow air to escape. Once rolled, tie a string or rope around tent to hold
into place. Place the rolled-up tent into carry bag.
STEP 2:
Lower the height of the canopy to the lowest setting to connect the tent
to the frame.
STEP 6:
Tie the three fabric ties located at the 2 sides
of the tent and the center back to the center of the canopy
frame.
WARNING:
Elastic cords can snap back and hit your eye.
To reduce the risk of injury to you and others:
• Keep your body and face clear.
• Do not over stretch elastic cords.
• Maintain firm grip on hook.
• Pull the hook toward you; if it slips it will spring away from you.
• Make sure hook is fully clipped to canopy before releasing.
• Wear protective eye wear during tent assembly.
Your failure to follow this warning could cause serious injury or
permanent disability.
Top view.
