Step 4: Connect leg sections, attach deck feet, attach S-hooks, stake legs
Step 3 : Position the fly
1) Place the fly over the roof frame positioning
corners over the corner connectors.
2) Recommend attaching top of mesh door
panels at this time.
1) Insert battery pack (batteries not included)
into battery pocket at end of eave and close
the flap.
2) Thread the light rope through the loops
along the roof line. Secure the end of the
rope to the clip.
Disassembly
1) To take down the tent, disassemble in
reverse order.
2) Remove accessories.
3) Remove and fold fly.
4) Be sure to leave doors and windows
unzipped to avoid zipper damage.
5) Remove stakes with hammer or stake puller.
DO NOT pull on tent.
6) Carefully disengage poles from pins. Push
poles away from you through the sleeves to
minimize risk of damage to tent or poles.
7) Keep poles and stakes together in bags
provided.
1) Along back side of the tent connect the bottom section of the leg poles(E) and attach deck
feet (12). This will raise the tent.
2) Repeat the process for the remaining legs (E) at front tent corners, leg poles
(E1, tapered ends on the awning).
3) Attach the brass J-hook at the bottom of the pole sleeve to one of holes at the bottom
of the pole.
4) Stake the sleeve to the ground through the attached D-ring.
5) Inside the tent attach hook and loop fasteners along the eaves
Step 6: Attach wall panel
Step 5: Secure guy lines
Step 7: Attach optional lights
Packing the tent
1) Spread tent flat, distribute evenly.
2) Fold into quarters not to exceed the length
of pole bag.
3) Lay pole bag at opposite end from door.
Tightly roll bag, skin and fly forcing air
through unzipped door.
4) Secure with ties and place in carry bag with
stakes and accessories.
5) Tent must be clean and dry before storage.
Store off concrete floor.
Be certain campfires are extinguished.
Dispose of trash appropriately.
Dimension A should
be close to but not
exceed the length
of the pole bag.
A
Fold tent into a
rectangular shape.
Front of tent
(door unzipped)
WT192114 10/18
Tent must be secured for proper function.
1) Secure party tent using all guy lines and
stakes.
2) Insert a stake through the stake loop and
hammer the stakes into the ground at a
45° angle using a hammer or mallet.
1) Attach wall and door panels using hook
and loop fasteners to the frame along the
eaves and legs.
2) Attach brass S-hooks to holes near the
bottom of the leg poles.
Attach at entrance: 2 mesh door panels and
2 mesh wall panels
Attach at side eaves: 2 largest windowed
wall panels.
Attach 5 remaining panels at front and rear
eaves.
