USER MANUAL Model No: 3219
Speed Control
The speed control, featuring five forward and three
reverse speeds, is integrated into the handle. Turn
the handle clockwise to move forward and anti-
clockwise to go backwards. When you don’t want to
move, set the handle into neutral. No power will be
used in this setting. Please see the image to the
right.
Warning: Remember to always disconnect batteries
once the motor leaves the water as a rotating
propeller can cause personal injury. Remember to
wash the motor using a fresh water after use in salt
water as this can greatly reduce the possibility of
corrosions.
Adjustment
Screw
Angle Adjustment
The motor found on the product is able to be adjusted by
way of the handle to make it more comfortable for the user
to control. Follow the steps below to make adjustments:
1. Loosen the adjustment screw (marked on the image to
the left). This will enable you to move the handle up and
down freely.
2. Keep the handle at the desired angle, ensuring that the
angle is suitable and will still allow control.
3. Tighten the adjustment screw to finish adjusting.
Warning: The adjustment range of the motor is 60°. DO
NOT exceed this limit as forcing the handle to rotate
How to replace the Propeller
Loosen the propeller knob found on the propeller
pin (this is where the propeller will be found).
This should allow you to pull the propeller off. If
the propeller gets stuck, grab one of the blades
and table on the opposite blade lightly with a
rubber mallet until the propeller comes off. If the
propeller pin (this is what holds the propeller in
place) is bent, replace it. Align the new propeller
with the propeller pin. Place the propeller knob
back onto the propeller bin and secure it into
place.
