13
7.
INSTALLATION OF THE UNIT
7.1.
Selecting the mounting location
The Unit should be installed in a heated room such as storage room, boiler room, garage or an attic.
Make sure, that there is sufficient space to install not only the Unit itself, but also auxiliary ventilation
system components – electrical heater, noise silencers or air distribution boxes. Make sure that there
is a possibility to connect the condensate drain pipe of the Unit to the building's internal sewerage
system.
Operating conditions:
+15
o
C - +30
o
C, relative air humidity <= 60%.
The Unit should be installed vertically. Mounting bracket (provided) should be used to fasten Unit to
the wall. Use wall pins or locking sleeves (not included), depending on installation surface. Use vibro-
isolation gaskets (not included) if necessary.
7.2.
Connecting ducts
It is recommended to connect the indoor and outdoor air intake and exhaust ducts to the Unit by
using couplings with rubber gaskets. It is necessary to seal the connection place well if any other type
of connections is used.
Figure 2. Air intake duct connection diagram
