User Manual -
SPARKJET U1
V1.1 06/2018
7/16
4. Operation guide
A - Installation
First make sure that you choose a safe place to use the product, keeping audience and flam-
mable materials at a minimum safety distance of 3 m. And keeping effect out of reach of the
public and any flammable materiels. Be sure that you have enough free vertical space above
the Sparkjet U1 (4/6m).
B - Powder feed
Before start, you should check that you have enough powder in the powder container.
If not feed it with and only with the powder SPARKJET U1 dedicated powder :
- Ref : SJ3M for 3 m high effect (Average)
- Ref : SJ5M for 5 m high effect (Average)
Before you open the powder container, please make sure that the Sparkjet U1 is powered OFF.
C - Start
Plugged the Sparkjet U1 with the dedicated powerCON.
And then push the Power button.
At start, you will see 4 reds dots chasing this mean that the Sparkjet U1 is heating.
When the Sparkjet U1 reach the good temperature the 4 reds Dots will stay fixed.
The average heating time is about 7 min from cold start.
D - Display Menu
To navigate thru menu use the button under the display
Push « function » button to display temperature of the heater.
Push « up and down arrow » to go into DMX mode and change address. The selected address
will work for both Wire DMX and Wireless DMX.
E - DMX Operation
Push "up and down arrow" to go into DMX mode and change address
The SPARKJET U1 have only 1 CH Mode using the following DMX Charts
CH1 - 000 to 065 – No function
066 to 128 – Low output
129 to 196 – Medium output
197 to 255 – Max output
