version 1.5 rev 4 Dec 2019
20
Sona &
Marana
3.5 c
onnecting
tHe
c
aMeRa
to
tHe
pc
The camera connects to a PC via USB 3 this provides a standard, robust and high speed connection with the control
PC. It is recommended to use the supplied USB 3 card as this will ensure consistent performance. Other USB ports on
the PC may share bandwidth with other devices and peripheral components. This may cause reduced, or inconsistent
performance.
3.5.1 i
nstalling
tHe
Usb 3 c
aRd
in
tHe
pc (
if
ReqUiRed
)
NOTE: Camera operation with PCIe cards not supplied by Andor cannot be guaranteed.
1. Unplug all cables from the rear of the computer.
Fasten the Card
to the slot
Unused filler brackets
Gently press the
card into the slot
PCIe 2.0 Slot
x4 recommended
2. Open the PC enclosure to gain access to the expansion slots.
3. Locate a suitable PCIe (2.0 or newer) slot:
• Card operates in an x1 slot or one with a greater number of channels (i.e. x4, x8 or x16).
4. If you are unsure which slot is correct, please consult the PC user manual.
5. Remove the filler bracket corresponding to the slot you intend to use.
6. Remove the controller card carefully from its protective ESD packaging and insert the card connector fully into
the expansion slot.
7. Ensure the card’s mounting bracket is flush with any other mounting or filler brackets to either side of it, then
secure the controller card in place.
8. Replace the computer cover and secure with mounting screws if applicable.
9. Reconnect any accessories you were using previously.
