19
the input signal, that is, trigger on the rising and falling edges of the input
signal.
Entering the edge trigging, the trigger setting information is displayed at the
bottom right corner of the screen, e.g.
. It indicates that the
trigger type is rising edge, the trigger source is CH1, the trigger coupling is DC,
and the trigger electrical level is -20.0mV.
The description of the trigger system setting menu is as follows:
Function
Menu
Setting
Description
Source
CH1
CH2
Set Channel 1 as the source trigger signal.
Set Channel 2 as the source trigger signal.
Coupling
AC
DC
Set to prevent DC component from passing
through.
Set to allow all components to pass through.
Trigger
type
Automatic
Normal
Single
Waveforms can be acquired without detecting
trigger conditions.
The waveform is acquired only when the trigger
conditions are met.
When a trigger is detected, a waveform is sampled
and then stopped.
1/2
Enter the next menu.
Edge
Rising edge
Falling edge
Trigger on the rising edge of the signal.
Trigger on the falling edge of the signal.
Trigger
centered
The trigger position is set in the middle of the
waveform.
Force
trigger
Forced trigger key, which forcibly generates a
trigger signal, mainly used in the "normal" and
"single" modes of the trigger mode.
2/2
Return to the previous menu.
Trigger electrical level
: The amplitude level that the signal must cross when
setting the waveform acquisition. Press the
Trig/
△
key to enter the trigger
menu, and press the
or
key to move the trigger electrical level up and
down.
