4
LCD Display Symbols
LCD Display Symbols
1. Alternating signal test
2. Direct signal test
3. Low Battery
4. Auto range mode
5. Diode test
6. Continuity buzzer
7. The maximum value is
being measured
8. This indicates that the
display data is being held
9. Ohms, kilo-ohms, mega-ohms resistance test
10. Amperes (current)
11. Milli-volts, volts (voltage)
12. Negative polar mark
13. "OL": The input value is too large for the selected range.
Button Function and Auto Power Off
1.
H
: For measuring data hold, press the H button, the peak value
of current data will be keeping displaying on LCD; press it again
to cancel this function.
2.
MAX
: Maximum data hold button, when press this button, the
A/D converter will keep measuring, and the display updating the
data and hold the maximum data.
3.
SEL
:
Function selection button, press for switching
ohm/diode/continuity function when tested objects change.
4.
Auto-power off
: If there is no any operation within any fifteen
minutes after power is on, the meter will auto power off. Turn the
rotary switch or press any function button to resume operation of
the meter under the auto power off mode. At the same time
when power on, if press the "
H
" button, auto power off will be
disabled.
