5.Front Panel Operation
22
To Output DC
(1)
Press
CH1/2
to select the channel that you want to output DC.
(2)
Press
button, then press
F4
to enter the
Built-in Wform
menu.
(3)
Press
F4
to select Others. Select DC. Press
F1
to output DC.
(4)
Press
F3
, confirm whether the "
Offset
" menu item is highlighted; if not, press
F3
to switch into "
Offset
". In
Parameter 3
, a cursor appears under the value of
offset. Use the
knob
or the number keys to set the desired value and choose the unit.
DC Voltage
Parameter 3
Figure 5-12: The DC Setting Interface
To recall wave file
This function can read the waveform file with suffix of (*.ota) which is cut from SDS series
oscilloscope manufactured by OWON and saved to USB device or cut by the software of
OWON oscilloscope. Then ARB waveform generators can output the same signal as the
cut wave.
Use SDS Series oscilloscope manufactured by OWON to cut wave:
(1)
Connect USB device to SDS series oscilloscope.
(2)
Press
Save
to call out the save menu.
(3)
Press the H1 button, the Type menu will display at the left of the screen, turn the M
knob to choose Cut Wave for type.
(4)
Move cursor1 and cursor2 to choose the range of wave to be cut.
(5)
Press the H2 button, and the input keyboard will pop up. The default name is the
current system date. Turn M knob to choose the keys, and press M knob to input the
chosen keys. Choose and press Enter key of the keyboard to end the input and store
the file with the current name to USB device.
