OWL OCM-C, Руководство по эксплуатации

Страница: 8 / 26

SCAN ZOOM LOCK
Fiber #1
CURSOR
ENTER
#54
#32
1X
60.0
48.0
36.0
24.0
12.0
20 69
-4.60dBm
1543.33nm
1552.12nm
0.78dB
-21.72dBm
-20.94dBm
H LAST
ABS
0.0
(50GHz)
4
Fiber ID
– name of the currently loaded test
Graph Data Mode
– results of current scan
LAST
most recent test taken
AVG
average power level
MIN
lowest power level
MAX
highest power level
Gain Level
– High (+) or Low (-) gain
OSA Status
– green is scanning; red is off
USB Connection Status
– shows whether or not the
USB cable is connected
Peak Detection
– channel peaks detected when
green, saturated peaks when red
Zoom Indicator
– shows whether Vertical (V) or
Horizontal (H) zoom is selected
Battery Life Indicator
– displays the remaining
battery life
Channel Bar Graph
– displays optical power levels for selected DWDM channels:
below the minimum power threshold
within acceptable tolerances
above the maximum power threshold
too high to be measured accurately
Vertical Zoom Level
– 1x, 2x, 4x, 8x, 16x; UP arrow to zoom in, DOWN arrow to zoom out
Optical Power Level Scale (y-axis)
– shows optical power level range (numbers are shown without negative sign)
Channel Numbers (x-axis)
– shows the beginning and ending channel number for the range of selected DWDM channels
Channel Spacing
– shows whether 50 GHz or 100 GHz spacing is selected
Channel Information
– shows the information for the channels where the red and green cursors are located
Channel Numbering
– displays whether the channel numbers are shown based on absolute ITU grid numbers (ABS) or on
relative scan channel numbers (REL).
Insertion Loss –
corrective insertion loss factor for passive devices such as the tap port of a splitter
Function Options Menu
– displays the on-screen menu options.
There are three sets of Function Options Menus. The Enter key ( ) is used to toggle between these three menus:
LOW
ACCEPTABLE
HIGH
OVER
DISPLAY
SECTION 1: INTRODUCTION
SCAN ZOOM LOCK CURSOR SETUP DATA LOAD SAVE CH# MENU UNITS MINMAX
MENU 1 MENU 2 MENU 3