Filename:CONTROL CENTER MANUAL
12/11/06
Page 8 of 10
Instructions:
RS232
Remote
Control of the OWI CCRC403
Control Center.
The communications settings are 9600 baud, 8 bits, no parity, 1 stop bit.
On the computer keyboard, use UPPER CASE letters for the commands.
Backview of CCRC403 showing RS232 connection
Typed Letter Action Typed Letter Action
Decrease channel 1 volume
Decrease channel 3 volume
Increase channel 1 volume
Increase channel 3 volume
Decrease channel 2 volume
Toggle channel 1 in and out of the line out mix
Increase channel 2 volume
Toggle channel 2 in and out of the line out mix
Toggle channel 3 in and out of the line out mix
The
J,K,L
keys do not affect the power amplifier output to the speakers or the three volume
settings.
Except for the
J,K,L
keys, holding a key down
(
A,S,D,F,G,H
)
smoothly moves the volume up
or down.
When a letter is typed, the CCRC403 sends back that same letter.
It is not necessary or desirable to press the enter key after a letter entry.
The last volume setting of a channel is stored in a special memory. When the CCRC403 is turned
off and then back on, the stored volume settings are restored to their respective channels.
The volume controls have stops at both ends so that the volume setting won’t wrap around from
minimum volume to maximum volume and vice versa.
In addition, decreasing the volume of a given channel past a certain minimum will mute that
channel.
When a channel is isolated from the line-out feed, the red overload LED for that channel on the
CCRC Control Panel will remain on steadily.
Tech Support: 310-515-1900
