05
DEVICE SETUP
3. Remove the cover and set it aside. If you are going to install a 2280 form factor M.2 drive, all you need to do is
remove the drive post screw (3B). By default, the screw and drive post should be installed on the 2280 form factor.
4. If you plan to install one of the other supported form factors, the drive post will also need to be removed so that
it can be re-affixed at the correct location. To move the drive post, remove the screw (4A), lift up the drive post,
and place onto the desired form factor location (4B). The flatter side of the drive post will rest over the desired
form factor location.
5. Align the connector on your M.2 drive with the connector on the ShuttleOne, then carefully insert the
drive until it is fully seated. Minimal force is required. If the drive does not seat, do not apply more force.
Remove the drive, re-align it, and try again. Afterward the drive will rest at an angle. This is expected.
3A
5B
4B
4A
3B
3C
