OWC Mercury On-The-Go Pro
Chapter 2 - System Setup
Slide the bridge card with the hard drive into the aluminum heatsink - there is a notch
that the bridge card will slide into.
Do NOT insert screws into the side of the drive through the heatsink.
Gently slide the completed heatsink, drive, and bridge assembly into the acrylic enclo-
sure.
Take 4 Phillips screws from the included plastic bag and once again, don’t fully tighten
the screws, just start them, as you will need to rock the assembly back and forth a bit to
get all 4 screws started, then you can tighten them. Note that there is a rubber mounting
strip on the bottom of the heatsink, that makes it a bit difficult to get the screws all the
way in. You may find holding the enclosure in your hand, screws down, works best.
➅
➆
