OWC Jupiter Callisto, Быстрый старт, Страница: 13 / 30

OWC JUPITER CALLISTO INITIAL SETUP
10
3.1 CONNECTION
Once the Jupiter Callisto is installed in the rack, the next step is to connect it to the network. Refer to
Section 1.5, Rear View
for the connectors on the Jupiter Callisto.
1. Connect the Jupiter Callisto to power. Make sure to connect all of the power supplies (two modules for the 8-bay, three
for the 16-bay).
2. Connect the Jupiter Callisto to your network using the two 10GBASE-T RJ45 ports. These ports are compatible with 10Gb
Ethernet as well as Gigabit Ethernet networks. These ports have been preset to the following configurations:
Port Mode IP Address Subnet Mask
LAN 1 (ix0):
DHCP automatic automatic
LAN 2 (ix1):
Static 192.168.0.1 255.255.255.0
3. Turn on the Jupiter Callisto using the power switch.
4. The Jupiter Callisto is configured to use DHCP on LAN 1, so it will receive an IP address automatically from a network that
is serving addresses via DHCP. The Jupiter Callisto is configured with a static IP address on LAN 2 to easily access the
management interface in the event a network with DHCP is not available.
5. To access the Jupiter Callisto and manage it, open a web browser on any client computer connected to the network and
enter the Jupiter Callisto’s IP address. Instead of the IP address, you can also enter ‘jupiter.local’ in the web browser.
3.2 FIRST TIME CONFIGURATION
The first time that any user connects to the Jupiter Callisto through the web interface, they will be prompted to set a new
password for the ‘root’ user, which is the user that has full administrator access to the Jupiter Callisto.
The next step is to set a password for the ‘root’ user in order to receive email alerts from the system. When the Jupiter Callisto
detects an error, it will issue an alert by sending an email to the ‘root’ user. Additionally, any active alerts can be viewed in the
upper right corner of the web interface.
There are two steps to setting up email alerts. First, expand the ‘Account’ section in the sidebar, then expand ‘Users’ and
select ‘View Users’. Next, click on the ‘root’ user to highlight it, then click on the ‘Change E-mail’ button at the bottom of the
screen. In the window that appears, enter the email address that you wish to receive alerts, then click ‘OK’ to confirm the
change. See
Figure 3.2a
, below.
Figure 3.2a
INITIAL SETUP