Page 10
.
Always follow these procedures to verify or replace the head light in order to avoid
damaging the carpet beater.
5. HOW TO REPLACE THE HEAD LIGHT
STEP 1
STEP 2
Do not remove the 3
screws in a triangle
formation as these hold
the motor in place
STEP 3
STEP 4
STEP 5
Replace the
lightbulb
The light is on when the vacuum is on. If the light does not turn on, this means it is burned out
and needs to be changed. Follow the steps below to achieve this.
Remove the old bulb from the socket
and replace it with the new one.
1-Disconnect the wand from the
electric carpet beater (powerhead).
2-Turn the electric carpet beater
(powerhead) so that the bottom is
facing you.
3-Remove the 7 screws as illustrated
above.
Turn the electric carpet beater
(powerhead) so that the top part is
facing you and lift the cover (B) to
remove it.
Unscrew the
powerhead cover
Remove the powerhead
cover
Put the carpet beater cover
back in place
Screw the power head
cover back in place
1-The wand port must be in the
upright position and locked in place.
2-Put the cover back on top of the
electric carpet beater (powerhead).
3-Turn the carpet beater (power-
head) over.
4-Replace the screws, as illustrated in
step 1.
Replace the 7 screws as illustrated
above.
