Overlander VSRmini, Руководство по эксплуатации

Страница: 11 / 24

6. Lithium Battery Programs
(LiIon/LiPo/LiFe/LiHV)
The beep sounds every time a button is pressed
to confirm your action. Beeps or melodies may be
sounded at various times during operation to alert
the user of different mode changes. You can turn
these sounds on and off.
This program monitors the input voltage to the
battery. If the voltage drops below the value you
set, the operation will be forcibly terminated to
protect the battery.
On this screen the top line displays the battery
type and the second line shows the charge
current and the voltage of the battery pack.
After selecting the correct current and voltage,
hold
Start/Enter down for 3 seconds to start the
process.
(Charge current: 0.1~6.0A; Voltage: 2-4S)
These programs are only suitable for charging and discharging Lithium batteries
with a nominal voltage of
3.3V (LiFe) , 3.6V (LiIon) , 3.7V (LiPo) and 3.8V (LiHV) per
cell. These various battery types will all have different charge voltages (CV) and
charge currents (CC). The charge current input varies according to the battery
capacity and performance, so it is very important that you select the correct
battery type before starting any process .
The final voltage of the charge process is also very important; it should be precisely
matched with the correct voltage of the battery. Per cell these voltages are:
3.6V for
LiFe , 4.1V for LiIon or 4.2V for LiPo
. The option for peak cell voltage of 4.4V for
LiHV should only be used if the battery instructions specifically allow this, to prevent
danger of overcharging. Otherwise select either 4.3V or 4.35V for LiHV . The charge
current and nominal voltage, as per the cell count set on the charge program, must
always be correct for the battery being charged.
If you wish to alter the default parameter value in the program, press Start/ Enter to
make the value blink then change the value with INC or DEC . The value will be
stored by pressing Start/Enter once.
6.1 Charging Lithium Batteries
< Dec Inc >
Display
Key Beep ON
Buzzer ON
< Dec Inc >
- +
Display
Input Power Low
Cutoff 10.0V
< Dec Inc >
- +
<Batt type Start > 3 seconds
stop Enter
Display
LiPo Charge
2.0A 11.1v (3S)
< Dec Inc >
- +
< Dec Inc >
- +
-
8
-