Overlander VSRmini, Руководство по эксплуатации

Страница: 10 / 24

This shows the trigger voltage for automatic
charge termination of NiMH and NiCd battery.
The effective value ranges from 5 to 20mV per
cell. If the trigger voltage is set higher, there is a
danger of overcharging the battery; if it is set
lower, there is a possibility of premature
termination. Please refer to the technical
specifications of the battery. ( NiCd default:
12mV , NiMH default: 7mV
)
This program sets the maximum charge capacity
that will be supplied to the battery during charge.
If the delta-peak voltage is not detected, or if the
safety timer is not working for any reason, this
feature will automatically stop the process when
the battery reaches the selected capacity value.
The 3-pin port at the left side is a temperature
port. You can use a temperature probe to contact
the surface of a battery. You can set the maximum
temperature at which the charger will allow the
battery to reach during charging. Once a battery
reaches this temperature during charge, the
process will be terminated to protect the battery.
This shows a battery that is on a cyclic process of
charge and discharge. These can often become
warm after the charge or discharge period. This
program can insert a time delay to occur after
each charge and discharge process to allow the
battery adequate time to cool down before being
subjected to the next process. The value ranges
from 1 to 60 minutes.
When you start a charge process, the integral
safety timer automatically starts running at the
same time. This is programmed to prevent
overcharge if the battery proves to be faulty and
the termination circuit cannot detect if the battery
is full. The value for the safety timer should be
generous enough to allow a full charge of the
battery.
< Dec Inc >
< Dec Inc >
< Dec Inc >
< Dec Inc >
< Dec Inc >
< Dec Inc >
Display
NiMH sensitivity
D.Peak Default
< Dec Inc >
- +
Display
Capacity Cutoff
ON 5000mAh
< Dec Inc >
- +
Display
NiCD sensitivity
D.Peak Default
< Dec Inc >
- +
Display
Safety Temp
Temp Cut-off 80C
< Dec Inc >
- +
Display
Waste Time
CHG/DCHG 5min
< Dec Inc >
- +
Display
Safety Timer
ON
120min
< Dec Inc >
- +
-
7
-