10401076-001
©2020-21 Overland-Tandberg
18
3
Installation Information
General Mounting Information
Figure 1:
Drive Mounting Details
Information
Description
Mounting
Positions
Mounting position is either horizontally with the Eject button and
indicator LEDs to the right, or vertically.
Mechanical
Dimensions
The Drive occupies a half-size 3.5-inch or 5.25-inch slot with standard
holes for 3mm mounting screws on both sides and at the bottom of the
Drive chassis. See
for the mechanical dimensions of the Drive.
Dimensions are in millimeters (mm). General tolerances: +/-0.5mm.
Screw and Torque
Use standard 3mm mounting screws (M3x0.5) with maximum screw
torque 0.5Nm. Maximum screw length is 5mm.
Cable Lengths
The recommended maximum SATA III cable length is 1 meter. However,
to increase system noise immunity, the cable should be kept as short as
possible.
Power Connector
The power connector is a standard 15-pin SATA power connector.
Chassis Grounding The Drive chassis must be grounded to the system chassis through the
mounting screws. Correct grounding of the chassis is important to
reduce radiated electromagnetic interference and for electrostatic
discharge (ESD) protection.
