10400469-002
12/2013
©2013 Overland Storage, Inc.
Page 2 of 5
Chassis Replacement Instructions
Remove the Drives
IMPORTANT: Overland recommends that you remove the disk
drives to reduce the unit’s weight prior to removal. They must
be replaced in the same drive bays in the new node.
NOTE: Do not remove the disk drives from their carriers. Doing so
voids the drive warranty.
Remove all the drive and blank carriers, noting from which slot
they were removed.
1.
Press the release
button
on the right side of the carrier.
2.
Using the built-in
handle
, pull the carrier out.
3.
Number the
carrier
and set it on a secure surface
4.
all
the remaining carriers, front and
rear.
Remove Node from Rack
WARNING:
It is recommended that a mechanical lifter (or at
least two people) be used during rack installation or removal
to prevent injury.
AVERTISSEMENT:
Pour éviter toute blessure il est
recommande qu'un monte-charge (ou deux personnes au
moins) soit utilisé lors de l'installation ou de l'enlèvement du
support.
1.
With a lifter positioned in front of the array, release the
two
captive screws
on the front flanges, and slide the
chassis out until it stops.
2.
Release the rail
locks
and continue to slide the chassis
out onto the lifter.
3.
Move the chassis onto a
secure surface
.
4.
Unpack the
new chassis
and place it next to the old one.
Transfer Components
Move Inner Sliding Rails
You need to move the attached inner slide rails to the new
chassis:
1.
Remove and retain the
screws
holding one of the rails on
the side of the old chassis.
2.
Slide the
rail
toward the rear, and remove it.
This may require some force as it is a tight fit.
3.
Position the
rail
against the side of the
new chassis
with
the locking tabs going through the holes on the rail.
4.
Slide the rail toward the front to lock it and secure it with
the
retained screws
.
5.
other rail
.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
Secure Surface
Old Chassis
New Chassis
Align Holes
to Tabs
