Overland Storage ARCvault Series, Инструкции по снятию и замене

Страница: 2 / 4

Part Number 10400038-102 04/2007
©2007 Overland Storage, Inc. W
Page 2 of 4
CAUTION: Do NOT turn the chassis upside down or allow
the front bezel or door to contact the table.
4. Remove the shipping screws underneath ( Figure 1 ):
a. Turn the unit onto its left side making sure the
front bezel does not touch the table .
b. Unscrew each shipping screw about one-half inch
leaving the screws in the well nuts.
c. Using the finger pulls, remove and retain the well
nuts and screws .
d. Carefully return the library to its normal, upright
operating position.
5. Opening the left door , remove and retain the screw
holding the shuttle bracket in place ( Figure 2 ).
Figure 2. Remove the Bracket Screw (Top View)
6. Remove the shuttle bracket ( Figure 3 ):
a. Slightly lift the bracket up to clear the shuttle.
b. Swing the rear of the bracket to the left aligning it
with the magazine bay.
c. Pull the bracket straight out and retain.
Figure 3. Remove the Shuttle Bracket
7.
Close the door .
8. At the rear, remove the AC receptacle label .
9.
Place all the packaging components, including the
bracket, in the box and set aside for the old unit.
To replace a chassis, you must first remove all the media
magazines and drive assemblies (
Figure 4 ).
Figure 4. ARCvault 48 Components to be Removed
CAUTION: Keep a loaded magazine level. Don’t hold
magazine by the handle; use both hands to support it.
Remove Magazines with Power On
1.
At the OCP Default screen, press Media > Mag
Access > OK (at the offline message) > Unlock All .
2. Open both doors and remove all the magazines .
Continue with “Remove Unit from Rack.”
Remove Magazines with Power Off
Should there be a loss of power, you can still access the
magazines using the Magazine Release Tool (MRT) or a
1mm (0.040 in.) diameter wire at least 5cm (2 in.) long.
1. Slide the MRT into the manual release hole under
the magazine handles ( Figure 5 ).
Figure 5. Manually Releasing a Magazine
Remove This Screw
Shuttle
Top Inside View
Bracket
Front Bezel
Well Nut
Left Door
Opening
Hole
AR
C
-0
12
3
b
c
a
Removing Magazines and Drives
A
R
C
-0
05
2
Drive Assemblies Magazines
AR
C
-0
06
8
Insert Tool
Media Magazines
Magazine Release Tool