Overhead door PowewrMax XL 4060, Руководство по эксплуатации и обслуживанию

Страница: 11 / 22

11
For Help, call 1-800-784-5028 or visit www.overheaddoor.com
A To program one Button of a Remote Control (Figure 12):
• Locate Learn Button and Learn Indicator Light near
Terminal Strip on Power Head (Figure 13).
• Press and release Learn Button. Red Learn Indicator
Light will blink 2 times per second.
• Press Remote Control Button once within 30
seconds. Red Learn Indicator Light will stay lit.
• Press Remote Control Button again. Red Learn
Indicator Light will go out, indicating that
memory is stored.
B Program each additional Remote using step A above
(up to seven).
Remote Control Operation
A Press Button on Remote Control. Garage door will move.
B Press Button again. Garage door will stop:
•
The door automatically stops at the end of the open or
close cycle.
C Press Button again. Garage door will reverse.
WARNING
A moving garage door may cause serious injury or death.
•
Keep people clear of opening while door is moving.
• Do not allow children to play with the Remote Controls.
If the Safety Reverse does not work properly:
•
Close the door and disconnect the Opener using the
Emergency Release Cord.
• Do not use the door Opener, Remote Controls, or
Wireless Keypad.
• Refer to the door and door Opener Owner’s Manuals
before attempting any repairs.
NOTE
• Each Remote Control must be programmed
separately.
• The Remote Controls will not cause the door
Opener to close the garage door if the Safe-T-
Beam® System is malfunctioning.
• When programming the Remote Controls, they
must be at least 24" from the Antenna Wire.
• If the red Learn Indicator Light blinks
approximately 4 times per second,
programming has stopped. If programming
has stopped, repeat the above steps.
• Each Button on a 2 or 3 Button Remote Control
is for a different Opener. You cannot use more
than one Button per Remote, per Opener.
• A maximum of seven Remote Controls or
Wireless Keypads can be stored into the
Receiver at one time. If a Remote Control
becomes lost, or if you want to delete a Remote
Control or Wireless Keypad, see “To Erase All
Receiver Memory.”
Learn Code Button
Figure 13 Learn Code Button and Indicator Light
1 Button Compact Remote
w/Docking Station
Figure 12 Remote Controls
3 Button Compact Remote
w/Docking Station
Frequency
Switch
C P
ROGRAMMING THE
R
EMOTE
C
ONTROLS
Programming 1:
A
CCESSORIES
To Erase All Remotes from Power Head Memory
A Press and hold Learn Button on Power Head for 10
seconds or until Learn Indicator Light goes out.
Memory is erased:
•
Program Transmitter/Receiver again as needed.
To Replace Remote Control Battery
A FOR NON-FLASHLIGHT MODELS
•
Pop off the back of the transmitter.
–
Use coin, pen, screwdriver or any similar device.
– Replace old Battery with new coin type battery.
• Replace back of remote.
B FOR FLASHLIGHT MODELS
•
Slide open battery cover.
–
Replace old Battery with new AAA battery.
• Replace battery cover.
Remote Control Operation Continued
D Some Remote Controls are equipped with a flashlight. The
logo is the button which operates the light. There is a
backlight under the button. When it does not light, it
indicates the battery needs replaced.
1 Button Remote
w/Flashlight
Figure 13 Remote Controls
3 Button Large
Remote
w/Flashlight
3 Button Remote
w/Flashlight
Flashlight Button
315 Mhz
390 Mhz
Frequency
Switch
315 Mhz
390 Mhz
Frequency Switch