Fig.2
3.
Next you will work your way down the front of the door. Starting at the top you
will see double-sided Velcro strips sewn to the edge of the cab. At these points
you will take the 3” adhesive Velcro and wrap them around the bar and then wrap
the double-sided strip around that to provide a secure grip. See fig.3.
Fig.3
4.
Now you will see an 8” and one tab sewn down the rear of the door. Place the
adhesive strip to match up with this tab. Also there are three more double-sided
strips sewn along the rear edge. Place 3" adhesive strips for these.
5.
Mark the locations for the stud snaps on the fenders and side panels. Carefully
ensure that they correspond correctly to the snaps in the enclosure, and then install
the stud snaps using only a #2 Phillips screwdriver.
CAUTION: Do not use a
power drill/driver as damage to the fuel tank can occur!
6.
To open and stow the doors, move the zipper fully rearward and fold the bottom
portion of the doors up. Then begin to form a vertical roll with the door by rolling
it inward from the front edge toward the rear of the door. Secure in place using
the two Velcro straps provided. Try to form a roll approximately 2” in diameter to
assure that the door will not protrude while stowed.
