Fix the mounting plate on the wall. (See instructions on the mounting plate installation).
Pull the home wire from the wall to get through mounting plate.
Connect the corresponding wire and put an electrical tape on the wires:
-White wire is Neutral Wire, N
-Green wire is Earth Wire, E
-Black wire is Live Wire, L
Place decorative cover F over mounting bracket by aligning holes with screws C and D and secure until
snug with decorative nuts A and B.
Mounting Plate Installation (SEE FIGURE.1)
1.
Determine appropriate location and height. Recommended approximately 58" from floor if mirror is
to be used while standing, 42" from floor for use while seated.
2.
Remove decorative nuts A and B from screws C and D. Separate mounting plate E and decorative
cover F.
3.
Using mounting plate E as a template, locate appropriate position for holes on wall and mark.
4.
Drill two holes to accommodate enclosed wall anchors I and J (Molly Bolts).
5.
Insert wall anchors into holes.
6.
Remove mounting screws G and H from wall anchors I and J.
7.
Holding mounting plate into position, thread screws G and H through mounting plate into wall anchors
and tighten.
MIRROR MAINTENANCE
1.
Make sure that LED lights are OFF before cleaning.
2.
Use a soft wet cloth to remove dirt and stains. Wipe with dry cloth afterwards.
3.
To protect the mirror from dust simply store it in its original box. Store out of reach of children in a safe
dry location.
TECHNICAL SPECIFICATIONS
Input Voltage:
110V (Hard wire)
Power:
9W
Hertz:
50/60Hz
3
ovente.com
