Oval SP493613B, Инструкция по эксплуатации

Страница: 23 / 95

Fixing The Leaf Skimmer
Unpack your Outlet, Inlet and Skimmer Box from the carton. Carefully read the POOL LEAF SKIMMER instruction
manual before you start to mount the Outlet, Inlet and Skimmer Box onto the pool wall.
Mark the position of the hole with a cross shaped cut in the centre of the opening. Allow for a little over-hang
around the edge. Use a sharp knife to trim off the remaining liner from the inside of the skimmer box and
Inlet and outlet openings
(See
diagram 43 and 44)
(Diagram 43) (Diagram 44)
WARNING! Cutting more than necessary will damage and void the pool liner, so please do it with extra care.
Follow the Skimmer Box Instruction Manual to install the Inlet and Outlet connection kit and Skimmer Box
to the pool wall. Carefully trim off any protruding part of the liner within inside the connections after installation.
Caution! Do not damage any part of the inside of the Skimmer box and Inlet and Outlet connections with the knife.
FILLING THE POOL WITH WATER
Before you fill the pool with water, thoroughly check to see if there are any loose screws, holes or tears in the liner.
Fill the pool until it is half way across the skimmer box opening or to the maximum water level or a minimum
of 15cm from the top of the pool wall (see diagram 45) to make sure water is entering the skimmer box opening.
WARNING! To avoid collapse, never leave the pool without water in it.
(Diagram 45)
Warning! The Filter Pump must be switched off if there are swimmers inside the pool!
Follow assembly instructions in the Sand Filter Pump Combo Manual.