Outlaw Audio
16
Your Outlaw Model Ultra-X12 Subwoofer is designed for
trouble free operation. If you follow the instructions in
this manual you should enjoy many years of high quality
listening enjoyment. However, as with any sophisticated
electronic device, there may be occasional problems
upon initial installation, or during the life of the unit. The
items on this list are a brief guide to the minor problems
that you may be able to correct yourself. If these solu-
tions do not rectify a problem, or if the problem persists,
contact us for assistance. The Ultra-X12 does not contain
any user serviceable parts. If you suspect a problem that
Troubleshooting and Service Information
may require service assistance, contact
customerser-
, or call at
866-688-5292
.
It is important that any repairs be carried out only by
Outlaw Audio Service Department. This will assure proper
service and preserve the protection of your Limited
Warranty. Keep your sales slip or receipt in a safe place
with this manual so that it will be available to verify the
purchase date, should you experience a problem covered
by our warranty.
If you won’t be using your system for an extended period of
time, it is always a good idea to turn the subwoofer off us-
ing the rear panel MASTER POWER switch. This will prevent
the automatic turn on circuits from accidentally powering
the subwoofer on, during your absence.
When the Ultra X-12 Subwoofer cabinet becomes dirty,
wipe it with a clean, soft, dry cloth. If necessary, first wipe
the surface with a soft cloth slightly dampened with mild
soapy water, then with a fresh cloth dampened with clean
water. Wipe dry immediately with a dry cloth.
NEVER use benzene, thinner, alcohol, or other volatile clean-
ing agent. Do not use abrasive cleaners, as they may damage
the finish of the cabinet. Avoid spraying insecticide, waxes,
polishing agents, or any aerosol product near the unit.
When You Are Away
Cleaning
Symptom
Solution
Humming or Buzzing Noise
Power down your system and remove the Interconnects between your components. Power
your system back on. If the hum goes away when the interconnects are disconnected, the
hum is coming from the rest of your equipment. Plug in the Interconnects one at a time for
each component until you come across the specific component generating the hum.
No output from the subwoofer
(POWER Indicator light does not
come on)
¼
Check that the power cord is plugged in securely at both ends and make sure that the
power outlet the subwoofer is plugged into is functioning properly.
¼
Check the fuse. The fuse is located just below the power plug on the subwoofer. Unplug
the power cord and remove the fuse holder with a screwdriver and check the fuse. If the
fuse is blown, replace it with a 5 x 20 mm 5A slow blow fuse.
¼
If the fuse blows again, the Ultra has most likely sustained internal component failure.
Email or call technical support for assistance.
The subwoofer is not receiving a
signal (Red POWER Indicator light
does not turn green)
Recheck the connections between the receiver/processor and the subwoofer. On the back of
the subwoofer, make sure the power switch is set to "auto" or "on".
No output from the subwoofer
(POWER INDICATOR light stays red)
Connect the signal cable to another subwoofer. If you get output, then the fault lies with the
Ultra. Please email or call technical support for further assistance.
No output from the subwoofer
(POWER INDICATOR light turns
green)
Please ensure your subwoofer interconnect cable is functional. To do this, replace your
interconnect with a known working cable. If you continue to experience a lack of output,
please contact technical support via email or phone.
Subwoofer
Driver Type
Down Firing, 12" Long-throw Woofer
Ports Dual
Amplifier Section
Amplifier Power Rating
350WRMS
Frequency Response
17Hz -160Hz ± 2 dB Max Extension
22Hz -160Hz ± 2 dB Max Output
Crossover Type
4th Order Low Pass Network
Crossover Frequency
60Hz to 120Hz and Bypass
Phase
0 to 180 Degrees
SPL
120dB
(subject to placement and room gain)
General
Dimensions including
21.25" x 16.0" x 23.0"
feet (HxWxD)
Weight
66 lbs
Specifications