Outlaw 7000x Скачать руководство пользователя страница 8

Страница: 8 / 14

Outlaw Audio

Connecting

hen making connections between

any components and the Model 7000x, or
when making connections to any speaker,
be certain that both the input devices and the

will be no unwanted signal transients that can
damage equipment or speakers, it is always
best to unplug all equipment before making any
connections. Modern electronic products often
have a standby mode that may be activated
even though the product may appear to be

posts is provided for each channel output. These posts will

accept bare wire, spade lugs, or banana type plugs (when

permitted by local safety agencies.)
Be sure to maintain the correct polarity between your

phasing is correct, all speakers move in and out at the same

time, preserving the imaging of the program material.

Out-of-phase connections will result in some speaker cones

moving in while others move out, causing indistinct or

confused imaging, and muddled, cloudy sounds. To avoid

incorrect phasing or polarity, be certain to use cable that

has distinct markings, colors, stripes, wording, or grooves

on each side of the speaker cable.

adhere to a consistent pattern of using one side of the

wire to the red terminals and the other side to the black

terminals. If you are using speaker cable with markings on

one side only, convention is to consider the marked side

of the wire as the red, or positive (+) connection, and the

non-marked side as the black or negative (-) connection.

Overview

Before you Begin

To assure that the signals received and produced by your

of clarity or resolution, we recommend that you use high-

quality audio interconnect cables and speaker wire. There

speakers, the type of speakers you use, personal prefer-

ences, or other factors.
Regardless of the brand or type of speaker wire selected,

multi-stranded copper with a gauge of 14 or less. Remem-

ber that in specifying wire, the lower the number, the

thicker the cable. Wire with a gauge of 16 may be used for

short runs of less than ten feet. We do not recommend that

you use any wires with an AWG equivalent of 18 or higher

due to the power loss and degradation in performance that
will occur.

tions

Connections

simple. Using high-quality audio interconnect cables,

match the output channel designations on the rear of your

processor (or other source equipment) to the input jacks

on the rear panel of the Model 7000x that have the same

channel name.
When making connections with RCA type plugs on inter

the plug into the jack.

Never twist the RCA plug when

plugging or unplugging.

Loose connections can cause

intermittent sound and may damage your speakers. The

barrel assembly of some high quality RCA plugs may be

very tight, and it is important to assure a proper connec-

tion between the interconnection cable and the input jack.

IMPORTANT NOTE:

Before attempting to plug/unplug

power. Failure to do so can potentially result in severe damage to

RCA Pre-outs

Model 7000x Connections

Positive terminal post is colored

red and labeled with the plus sign (+)

Negative terminal post is colored

black and labeled with the

minus sign (–)

When making connections with XLR interconnects, the
three pins on the connector to need align with the jack.
When removing connections, make sure to press and
hold the locking tab while pulling the XLR connector
straight out.

XLR Pre-outs

SUB1

SUB2

Input Switch

Ensure your input switch, for each channel, is set prop-
erly; i.e. if using XLRs, set the switches to XLR.

Ensure your Input Selector Switch is set correctly.
For example, if using RCAs, set the switches to RCA;
if using XLRs, set the switches to XLR.
If set improperly, you will have NO audio!

7.2 CH OUT

XLR

RCA

RCA IN

XLR IN

Model 7000x