Outlaw 7000x, Руководство пользователя

Страница: 10 / 14

Outlaw Audio 8
Remote Trigger Connection
The Model 7000x features a trigger circuit to allow another
Ô
To use another device with a 12 volt trigger output
jack to automatically power on the Model 7000x:
1. Set the MANUAL/TRIGGER switch on the rear panel
of the Model 7000x to the Trigger position.
2. Connect the supplied 3.5mm mono mini-plug from
the trigger-output jack of the source device to the
When the switch is set to TRIGGER, and the front
power switch is set to ON, the blue ring around the
Power button glows dimly indicating the amp is in
Standby mode. When the connected device is turned
on, the Model 7000x turns on and the blue ring glows
brightly.
If you set the MANUAL/TRIGGER switch to Trigger, but don't
connect the Model 7000x to another device with the REMOTE
TRIGGER cable, the blue ring around the Power button will glow when the
Model 7000x
Remote Trigger Connection
Model 7000x Power Connection
If your processor or receiver does not have a dedicated trig-
ger jack, it is still possible to activate the unit for automatic
turn on when a switched outlet is available on the rear of
the source device. You will need a small AC to DC power
converter, capable of delivering a 4 to 12 volt DC signal.
The DC cable should be terminated with a mono 3.5mm
mini plug. This type of converter may be obtained as a
Power Adapter from electronics retailers.
Ô
To use an external AC to DC power converter to
automatically power on the Model 7000x
1.
Plug the AC adapter into a switched outlet that
will be activated when you wish to have the ampli-
This may be the switched outlet at the rear of an AC receiver
or other audio equipment.
2. Connect the 3.5mm mini-plug from the AC adapter
to the REMOTE TRIGGER jack on the back panel of
on the status of the controlling device.
n
Power Connection
Once all audio and system connections have been made,
connect the supplied power cord to the AC Input on the
rear panel of the Model 7000x and an AC power source.
when plugging the power cord into an AC outlet.
CAUTION:
Do not plug the Model 7000x directly into the
“Switched Accessory” outlet of another device! These
outlets are intended for use with low current draw products having
a low current draw, such as tuners, CD players or cassette decks.
These outlets cannot handle the high current draw of a power
safety hazard.
It is not recommended that you connect other power
same AC power circuit as the Model 7000x, unless they are used
with the remote power turn on and sequencing system. The
may cause circuit breakers to trip, due to the high current draw.
AC Wall Outlet
Set the MANUAL/TRIGGER
switch to Trigger
XLR IN
RCA IN
XLR RCA
LEFT
+
-
CHASSIS
GROUND
120V 60Hz 1800W