6
12. Peg out all the remaining pegging
points and guy lines starting from the
corner against the caravan and work
round the awning.
Warning: Never unzip the zips on the protective
sleeves whilst the AirFrame Tubes are inflated. This
may result in the tube bursting or ballooning out of the
sleeve - causing damage to the tube and the sleeve.
Visit the website for Video Instructions
13. Peg out the Reflective Endurance
Storm Straps for extra stability. Please
make sure in heavier weather you use all
the guy lines and storm straps to hold
the awning in place.
11. Then peg out and tension the front of
the awning. Use the adjustable pegging
straps to tension the awning as you desire.
Make sure you don’t over tension the fab-
ric. If a door is taut it may be too tight and
that could cause damage.
13. Finally - thread the draught skirt
through the lower awning channel and
secure at either side.
Fold the awning lengthways to
make a long thin straight line.
Packing away your awning.
Zip up all the windows and doors before deflating.
Unpeg the guy lines, storm straps and most of the pegs around the
awning - leaving the four corners pegged out.
Open the Dynamic Speed Valve and press in the quick release button.
Leave the button pressed in.
Unpeg the four corners and pull the awning out of the awning channel.
Lay the awning flat on the ground.
Measure the width of the bag
up against the width of the fold-
ed awning to make sure the
awning is going to fit.
Begin to roll the awning as tight
as possible from the opposite
end of the Valve to expel all the
air as you roll.
Place the rolled awning on to
the bag and pull the sides up
round it. Finally, Zip up the bag.
7
