ERECTION INSTRUCTIONS.
Outdoor revolution tents are all erected outer first
1.
Lay the outer/flysheet spread out on the ground. Slacken adjusters off on the black tapes (near the ring
and pin assemblies) around the foot of the awning.
2.
Open the pole bag and lay the poles out on the ground. Take one of the shaped fibreglass poles and open
it out, then slide it diagonally through one of the seams on the roof and down to the bottom corner at the
other side. Repeat the process with the other fibre pole, complete this by placing the steel pin on the ‘ring
and pin’ assembly into the foot of the fibre pole. SPARE POLES CAN BE PURCHASED FROM
3.
You will find by now the awning has formed a dome shape and should now be standing.
4.
You are now ready to peg the awning out, (
unless attaching to a motorhome- see notes below***)
Firstly, make sure all zips are closed. Starting at one corner; peg all the pegging points around the tent.
(Take care not to over tighten the tent, if a door zip is tight it is probably stretched two tight)
5.
Guy lines can now be tensioned and pegged on the awning and canopy, please ensure in heavy weather
that
ALL
guy lines and stability straps are used. (Please note that failure to use all the lines may result in
your tent being damaged)
6.
You are now ready to back your vehicle up to the Movelite XL. Offer up the ‘tunnel’ at the back of your
awning to the desired position and secure the tunnel in place up to the roof of your vehicle. Then adjust
the buckles and straps on either side of the tunnel to get a better fit and then finally tension the elastic
toggles to create a better weather seal.
***Note
, to attach the movelite XL to a Motorhome Fiamma/Omnistor you will need to purchase a driveaway kit
consisting of double edged awning piping an figure 8 joining strips. Simply slide into the awning rail, then the tent is
lined up and the figure 8 is positioned to join the two.
ADDITIONAL FEATURES ON YOUR MOVELITE XL
1) Combined fibre pole system for ease of assembly and greater stability.
2) Fly screens on both doors
3) Ring & pin system at foot of awning to locate poles
4) Pockets on tunnel to stow rear panel
5) Both side panels zip out to take annexe(either side)
6) Locating points to take inner tent (optional extra)
7) 3 x Velcro tabs (above tunnel entrance) to locate light flex and centre loop on roof to hang light
8) Profile and toggle hooks (above side panels) to take sun canopy (optional extra)
9) Adjustable buckles and straps on inside of tunnel to achieve a better fit
Please note these few points for trouble free camping.
a.
After use please you always dry and air the tent before packing away.
b.
Any dirt or stains can be removed by brushing or gently washing with warm water. DO
NOT use detergents as this will destroy the waterproofing on the fabrics.
c.
We advise that you DO NOT cook or smoke in this tent; although the outer fabric is fire
retardant treated it will still melt.
d.
Please make sure that you have a good time.
**We highly recommend that you insure your awning against storm
damage or accidental damage, as the warranty does not cover such
eventualities. The manufacturer is not liable for any damage caused
to the caravan or vehicle because of misuse, incorrect pitching or
extreme weather**
Outdoor Revolution Tents are distributed by:
Blue Diamond Products Ltd
