9
Plug both BLACK wires hanging from the burner into the back of the CF-
SPARKER. If an orange wire is present, do not use it. The orange wire is for
Direct Spark Ignition system only.
Test system by pushing the button on the igniter. Consult the
troubleshooting section of the Crystal Fire Burner Owner’s Manual if the
spark is weak, intermittent, or not present.
TIGHTEN ALL CONNECTIONS SECURELY WITH TWO WRENCHES
• Orient burner so electrode is nearest to the control panel
in order to make CF-SPARKER box connections.
Burner Installation
6.
•
Ensure the correct orifice is installed for the fuel type you
are using (see Crystal Fire Burner Owner’s Manual included
with burner for orifice sizing information).
•
Ensure flex line is securely tightened to the orifice.
Use two
wrenches as shown.
One wrench on the flex line and one on the orifice for
counter torque.
•
Connect flex line from the burner to the control valve on the base.
TIGHTEN CONNECTION
SECURELY WITH TWO
WRENCHES
• Carefully place burner into burner opening.
Electrode Installation
7.
Flex line from burner
IMPORTANT
Please consult your Crystal Fire instruction manual for detailed instructions and important
information related to the burner installation including: lighting and operating instructions, safety
information, and proper tightening of connections with two wrenches.
DO NOT ATTEMPT TO INSTALL CRYSTAL FIRE BURNER WITHOUT FIRST CONSULTING THE CRYSTAL FIRE
OWNER’S MANUAL.
