www.outcastboats.com
~ 800-966-0976
Warranty
This warranty covers defects in materials and workmanship only for a period of 5 year from the date of purchase from
the original owner for non-commercial use.
Outcast reserves the right to determine whether to repair or replace any product covered by this warranty and the
right to replace any discontinued models with current models when necessary. Colors may vary between original
and replacement parts.
If you have any questions, please contact your nearest dealer or
Outcast Sporting Gear
2021 E. Wilson Lane
Meridian, ID 83642
ph: 800-966-0976
www.outcastboats.com
Thank you for choosing Outcast products.
Extensive Repairs
If you have a major rip or tear in your boat that is beyond your abilities to repair, please contact Outcast at 800-966-0976
for a Return Authorization (RA) number. Please put a brief note with your contact information and a detailed description of
the repairs necessary inside the box and ship the package to the address below with the RA number clearly written on the
outside of the box. For your protection, please ship the boat with a service that provides a tracking number.
Glue Repair
Items Needed
:
Scissors or Knife
Standard Screwdriver
Roller
Stabond 2-part adhesive
Sand Paper
Popsicle Stick
Small Brush
PVC Material or Urethane Material
MEK or Alcohol Prep Pads
For most repairs, the airecell does not need to be removed completely. When patching the AIREcell, apply the patch to the
outside of the airecell. When patching the PVC shell, apply the patch on the inside of the PVC.
1. Locate the hole in the boat and access that area of the AIREcell and outer skin by opening the zipper.
2. Using a towel, dry the area to be worked on.
3. Cut a patch of fabric at least two inches large in length and width than the puncture, hole, or tear.
4. Clean the area to be patched (using MEK or alcohol prep pads).
5. Rough up both the patch and the area to be patched with the sand paper.
6. After opening the 2-part adhesive, prepare the Stabond glue by pouring the entire contents of the glass jar into the
metal can and stir using a popsicle stick or tongue depressor.
7. Apply an even coat of glue with a small brush to both the patch and the area to be repaired and let dry completely,
approximately 10-15 minutes.
8. Apply a second coat of glue, and let dry 5 minutes or until tacky. If the glue is too dry, reactivate it with a small amount
of cleaner.
9. Place the patch over the hole or tear, and press together. Using a roller or another blunt object press from the center
of the patch to the edges to seal the patch to the AIREcell or outer skin. Make sure that the patch seals completely
and is without bubbles.
10. Let the glue cure at least one hour before inflating (overnight if possible is best). Do not inflate to full pressure on the
same day of the repair.
