Outback GTFX2012E, Руководство по установке

Страница: 13 / 56

11
AC
Follow these steps to wire the FX to your system:
1. Shut all AC breakers off or remove any fuses before connecting any wiring.
2. Shut off all DC breakers, including the PV breakers.
3. With all power off, run lengths o
f 10.0 mm
2
(8 AWG) or larger wire between the AC Wiring
Compartment Board AC OUT terminals and sufficient overcurrent protection via an AC circuit
breaker. This breaker should be sized to protect the wire you are using, but should not exceed the
maximum AC input current of the FX model used in the system (see FX product specifications,
beginning on page 36). The breaker should be installed inside of a metal chassis such as OutBack’s
FLEXware series or an existing panel.
4. With the over current protection connected, run lengths of 10.0 mm
2
(8 AWG) wir e between the
AC Wiring Compartment Board AC IN terminals and the AC input breaker. The breaker should be
installed inside of a metal chassis such as OutBack’s FLEXware series or an existing panel. The AC
input hot conductor must be supplied through an AC branch-rated circuit breaker from your main
electrical panel or source.
This breaker should be sized to protect the wire you are using, but should
not exceed the maximum AC input current of the FX model used in the system (see FX product
specifications, beginning on page 36).
WIRE CONNECTIONS
Note: A system’s individual voltage requirements (230 VAC single phase or 3-phase), as well as how
each FX is to function, all determine how the inverters are wired. Each FX must be wired to a specific
leg or phase of the system. Each FX must be programmed or “stacked” according to this phase. Please
see the STACKED FX SYSTEMS section, beginning on page 25, and the International Series GTFX and
GVFX Grid-Interactive Inverter/Charger Programming Manual, before conn ecting any wires to or from the
FX inverter.