OutBack Power GS-IOB-230VAC, Руководство оператора

Страница: 72 / 76

Radian Series
6
900-0128-01-00 Rev B
Replacement of the Fan
Tools

Short (stubby) Philips screwdriver
Procedure
To replace the fan:
1. Remove the fan wire from the PCBA Module for the fan that is to be replaced by pinching its connector
and pulling to the right. Refer to Figure 3.
2. Using the short Philips screwdriver, remove the four screws attaching the fan to the Power Module.
Note the orientation of the fan to ensure that the airflow of the replacement is correct (airflow is “up”).
Figure 8 Fan Screws
3. Install the replacement fan by reversing steps 1-2.
Replacement of the Front Cover
Tools

Philips screwdriver
Procedure
To replace the front cover:
1. Prior to replacement of the cover ensure no tools or loose hardware has been left inside the chassis.
Also ensure that all electrical connections have been made. These include the AC input and output
terminations, MATE3 cable, Auxiliary wires, RTS cable, two ribbon cables (both ends), two fans, and the
six connections from the Power Module to the PCBA Module.
2. Use a Philips screwdriver to insert the 22 screws that attach the cover to the chassis. Tighten screws to
“finger tight,” as excessive torque may warp the cover. Refer to Figure 2.
Fan Screws
Fan Screws
Fan Screws
Fan Screws