Oursson MS3031, Инструкция по эксплуатации

Страница: 7 / 20

7
PRODUCT SET, РIС. В
1 Pusher................................................................. 1 pc.
2 Cover with holes ................................................. 1 pc.
3 Body .................................................................... 1 pc.
4 Plastic cup........................................................... 1 pc.
5 Strips shredder.................................................... 1 pc.
6 Slices shredder ................................................... 1 pc.
7 Dicing disc........................................................... 1 pc.
8 Nozzle cleaner .................................................... 1 pc.
Instructions manual ................................................ 1 pc.
Guarantee sheet ..................................................... 1 pc.
ELEMENTS OF DESIGN, РIС. C
1 Loading hole
2 Button for unlocking the cover
3
On button
4 Rubber Feet
5 Cup handle
6
Shredder holes for fingers (for easy installation of
the shredder in the body of the device)
7
Two flat pins on the body of the device for installing
a disk-attachment and corresponding holes on the
disk-attachment
7
UTILIZATION
Before first use, wipe the body of the device with a
soft, dry cloth. Cup
4
, cup’s cover
2
, shredder
5
and
6
, disc-nozzle
7
and pushers
1
wash with warm
water and dishwashing liquid. Thoroughly dry all parts.
Wipe them with a clean dry cloth.
Before assembling
or disassembling the device, make sure that the
device is unplugged.
Assembly order, Pic. D
1. Place the device on a flat and stable surface.
Place the cup into the body of the device and turn it
clockwise until it stops, Pic. D-1.
2. Place the shredder or dicing disc into the body of the
device, Pic. D-2..
Installing the shredders:
Take the shredder and install it into the device by turning
it slightly clockwise. For convenience and safety, the
shredders have finger holes. When installing, the knife
on the shredder should face the cover unlocking button.
To remove the shredder, turn it counterclockwise.
Installing the dicing disc:
Take the dicing disc with the knife up and place it in
the device on the two flat pins, the holes for the dicing
should face the cover unlocking button, Pic. C-7. To
remove the disc, press the cover unlocking button and
gently pull out the disc by holding the plastic edge.
3. Place the cover with the loading hole until it clicks into
place, Pic. D-3. Depending on which side you put the
cover on, you will end up with a shredded product in
strips/slices or a wide/fine spiral. For shredding with
strips or slices, place the cover with the loading hole
to the right, Pic. D-6. For shredding with a wide or
narrow spiral, place the cover with the loading hole to
the left, Pic. D-6.
4. In order to remove the cover, press the unlock button,
Pic. D-5.
Order of operation:
1. Assemble the device as indicated in the previous
section, Pic. D-1 – D-3.
2. Plug in the device.
3. Switch on the device by pressing the button, Pic. C-3.
4. Using the pusher, place washed and, if necessary,
peeled and cut ingredients into the loading hole,
Pic. D-4.
5. After the shredding is finished, turn off the device and
unplug it.
Maximum time of continued use of the
device – 15 minutes. The interval between
the cycles should be 10 minutes.
Do not chop ingredients whose temperature
is above 80°C. Let them cool.