Otto Bock Start M4 XXL, Инструкция по эксплуатации

Страница: 17 / 32

19
6.7.2 Adjusting the seat upholstery
The seat upholstery usually does not need to be adjusted during the initial fitting. However, the tension can be
changed.
INFORMATION
You can slightly correct the centre of gravity by making small changes to the sag of the seat upholstery. However,
larger corrections to the centre of gravity must be made by making changes to the settings on the frame, the drive
wheel adapter and the caster wheels.
1) Fold the wheelchair and remove the seat cushion.
2) Remove the protective caps (see fig. 20).
3) Remove the seat upholstery from the crossbrace (not illustrated).
4) If necessary, tighten the seat upholstery with the aid of the hook-and-loop fastener on the bottom of the seat
upholstery (see fig. 21).
5) Push the seat upholstery onto the crossbrace.
6) Slide on the protective caps.
7) Unfold the wheelchair. In doing so, the crossbrace must be seated fully in the support guides.
20 21
6.8 Adjusting the leg supports
6.8.1 Adjusting the lower leg length
The required legrest height depends on the lower leg length of the user and the thickness of the seat cushion.
“Segmented, angle-adjustable” leg support, “continuous” leg support, “elevating” leg support
1) Loosen the Allen head screw:
→
“Segmented, angle-adjustable” leg support: see fig. 22
→ “Continuous” leg support: see fig. 23
→
“Elevating” leg support: see fig. 24
2) Adjust the foot plate bar to match the user’s lower leg length.
INFORMATION: Ensure that the foot plate bar is inserted into the swivel segment by at least 40 mm
(to the marking).
17 Start M4 XXL, Start M6 Junior
Settings