Otto Bock Avantgarde Teen2 T, Инструкция по эксплуатации

Страница: 10 / 32

Drive wheel position Effects
• The seat height can be further adjusted in combination with a height
adjustment of the caster wheels.
The drive wheel can be installed at 13 height positions in the drive wheel adapter (see fig. 2; see fig. 32,
item 1–13).
1) Remove the wheels.
2) Loosen the hexagon nut (see fig. 3, item 1) on the quick-release axle receiver bushing (see fig. 3, item 2) on the
inside of the drive wheel adapter so that the camber washers can be pushed apart slightly.
3) Move the quick-release axle receiver bushing together with the hexagon nuts and camber washers into the
desired position.
4) Engage the lugs of the camber washers at the desired new position.
5) Firmly retighten the hexagon nut (see fig. 3, item 1). Make sure that the position of the camber washers for the
wheel camber is not changed.
6)
If needed:
The distance between the drive wheel and the side panel can be adjusted continuously by turning
the counter nut (see fig. 3, item 3).
7) Tighten the hexagon nut and counter nut on both sides of the quick-release axle receiver bushing to 50 Nm
(see fig. 3, item 1/3).
INFORMATION: Once changed, the left and right quick-release axle receiver bushings must both have
the same vertical position in the frame.
8)
If necessary:
Readjust the height and alignment of the caster attachment device as well as the wheel locks
(see information at the start of the section).
2 3
6.2.3 Adjusting the drive wheel camber
The modular system of the product offers camber washers for different sloped settings of the rear wheels.
The rear wheel camber is adjusted by exchanging the camber washers or adding camber washers on the quick-
release axle mounting. This has the following effects:
Position of drive wheel Effects
0° position
• Narrow track, excellent straight-line stability
• Low rolling resistance
Wheel camber
• Wheelchair becomes more manoeuvrable, turns faster and tips less easily
to the side
• The wheel position protects the hands when turning the handrim
• Overall width increases
• Increased rolling resistance
The drive wheel camber can be set to 0°, 2°, 4°, 6° or 8°.
The settings can be configured with a corresponding number and alignment of the 2° camber washers:
drive wheel camber (see fig. 4) Position on the drive
wheel adapter (see
fig. 4)
0° 2° 4° 6° 8°
Exterior 1x camber
washer
Alignment A
1)
1x camber
washer
Alignment A
1)
1x camber
washer
Alignment B
2)
2x camber
washer
Alignment B
2)
3x camber
washer
Alignment B
2)
10
Settings
Avantgarde Teen2 T,
Avantgarde Teen2 VR