Otto Bock 2R31 Series, Инструкция по эксплуатации

Страница: 8 / 104

Prohibited environmental conditions
Solids:
highly hygroscopic particles (e.g. talcum), dust in high con­
centrations (e.g. construction site), intensive contact with sand
Chemicals/liquids: salt water, perspiration, urine, acids, continu­
ous use in liquid media
2R31*
Allowable environmental conditions
Temperature range:
–10 °C to +45 °C (14 °F to 113 °F)
Chemicals/liquids:
fresh water, salt water, perspiration, urine,
soapsuds, chlorine water
Moisture:
Submersion: max. 1 h in 3 m depth, relative humidity: no
restrictions
Solids:
Dust, occasional contact with sand
Clean the product after contact with humidity/chemic­
als/solids, in order to avoid increased wear and damage
(
Cleaning
).
Unallowable environmental conditions
Solids:
Highly hygroscopic particles (e.g. talcum), continuous con­
tact with sand
Chemicals/liquids:
Acids, continuous use in liquid media
2.4 Lifetime
This product was tested by the manufacturer with 3 million load
cycles. Depending on the user’s activity level, this corresponds to a
maximum lifetime of 5 years.
3 Safety
3.1 Explanation of warning symbols
CAUTION
Warning regarding possible risks of accident or
injury.
8
3.2 General safety instructions
CAUTION!
Risk of injury and risk of product damage
►
Comply with the product's field of application and do not expose
it to excessive strain (see page 7).
► Note the combination possibilities/combination exclusions in the
instructions for use of the products.
►
Do not expose the product to prohibited environmental condi­
tions.
► Check the product for damage if it has been exposed to prohib­
ited environmental conditions.
►
Do not use the product if it is damaged or in a questionable con­
dition. Take suitable measures (e.g. cleaning, repair, replace­
ment, inspection by the manufacturer or a specialist workshop).
►
To avoid the risk of injury and product damage, do not use the
product beyond the tested lifetime.
► To avoid the risk of injury and product damage, only use the
product for a single patient.
►
To prevent mechanical damage, use caution when working with
the product.
► If you suspect the product is damaged, check it for proper func­
tion and readiness for use.
►
Do not use the product if its functionality is restricted. Take suit­
able measures (e.g. cleaning, repair, replacement, inspection by
the manufacturer or a specialist workshop).
Signs of changes in or loss of functionality during use
Among other factors, changes in functionality can be indicated by an
altered gait pattern, a change in the positioning of the prosthetic com­
ponents relative to each other and by the development of noises.