Otto Bock 2C7, Инструкция по эксплуатации

Страница: 16 / 132

NOTICE
Grinding the footshell
Premature wear resulting from damage to the footshell
►
Do not grind the footshell.
►
Inform the patient.
5.1 Installing the footshell
> Tools required:
Vice, 704G30 clamping tool, 2C101 footshell replacement tool, flat
screwdriver, T10 Torx screwdriver (see fig. 4 –
)
1) NOTICE! Proceed carefully during installation.
Do not damage the spacer lug and cables with the footshell
replacement tool (see fig. 2).
2) Insert a flat screwdriver into the groove and push the cover plate
out of the cover cap (see fig. 3).
3) Unscrew the screws (see fig. 4).
4) Remove the cover cap .
5)
NOTICE! Do not damage the plug connection and cable. Do not
pull on the cable.
Pull the plug of the cable out of the receptacle in the cover cap
(see fig. 5).
6)
NOTICE! To protect the pyramid adapter, use the 704G30 clamping
tool.
Clamp the clamping tool into the vice (see fig. 6).
7) Mount the pyramid adapter of the prosthetic foot in the pyramid receiver
of the clamping tool.
8) Pull off the old footshell, if any, according to the section "Removing the
footshell" (see Page 17).
9) Bring the prosthetic foot to maximum plantar flexion (see the instructions
for use of the prosthetic foot).
10) Fold the spacer lug in the proximal direction (see fig. 7).
11) Slide the footshell as far as possible onto the prosthetic foot .
12) Insert the tool into the footshell along the sole .
13)
NOTICE! Do not excessively deform the footshell while pulling it
on. Do not puncture the folds in the footshell with the tool.
Pull the posterior edge of the footshell over the sole with the tool
(see fig. 8).
14) Engage the sole in the adapter of the footshell (see fig. 9).
15) Engage the spacer lug in the adapter of the footshell.
16