Otto Bock 17AS5 Series, Инструкция по эксплуатации

Страница: 15 / 116

Drilling bars
Holes may be drilled in the bars.
►
Drill the holes for the mounting material in the bars. The distance
between the hole and the outer edge of the bar must be at least equal to
the diameter of the hole.
►
INFORMATION: The holes must not be repaired or filled under any
circumstances.
Installing mounting materials
► Install the mounting materials.
INFORMATION: Make sure that the mounting materials do not
obstruct the locking mechanism.
Final assembly of orthosis joint
► Use the 633F7 special lubricant to grease the metal.
► Secure the screw connection with Loctite 241.
6 Patient information
Inform the patient:
Inspect the orthosis for damage
► Inspect the orthosis for damage daily, paying special attention to the
stops and bars. Contact the qualified personnel promptly if changes are
noted.
7 Cleaning
Promptly clean the product after contact with water containing salt, chlorine
or soap, or if it gets dirty.
1) Rinse the product with clear fresh water.
2) Dry the product with a cloth or allow it to air dry. Avoid exposure to direct
heat (e. g. from an oven or radiator).
8 Maintenance
INFORMATION
The product may be exposed to increased loads by the patient.
► Shorten the maintenance intervals according to the expected loads.
The manufacturer requires an inspection of the product every 6 months to
verify functionality and check for wear at a minimum.
Only use 633F7 special lubricant.
A service kit can be ordered for product maintenance.
Spare parts are listed in the section "Components/design".
15