STEP 6
– ATTACH SCREEN (NOT USED WITH MIXER)
FRACTIONAL SERIES MIXER ASSEMBLY
STEP 1
– PLACE POWER UNIT BETWEEN BRACKETS
STEP 2
– POSITION UNIT & TIGHTEN BOLTS
FRACTIONAL SERIES MIXER PITCH ADJUSTMENT
LOOSEN BOLTS, POSITION & TIGHTEN
Max. Torque 8N-m / 70in-lb
ALIGN FLATS ON
HOUSING RING
TO BRACKETS
POSITION CABLE
CONNECTION
FACING FLOAT
USE 10mm WRENCH
Max. Torque
8N-m / 70in-lb
ALWAYS FASTEN
CABLE TO BRACKET
AS SHOWN
PREVIOUSLY
LOOSEN 4
BOLTS
(2 EACH SIDE)
FLOAT BRACKET
HOLES FOR MIXER
FASTEN
SCREEN TO
LIP
PLACE CABLE
BETWEEN FLOAT
& SCREEN
(TIE TO FLOAT)
USE SCREEN TO PREVENT PUMP CHAMBER
CLOGGING DUE TO LARGE DEBRIS
(GEMINI & HIGH VOLUME LESS PRONE TO CLOGGING)
FASTEN SCREEN (8) PLACES EVENLY SPACED
USE DRIVER OR PRE-DRILL 2.5mm (3/32”) HOLES
WHEN NOT USING SCREEN REPLACE SCREWS INTO HOLES
ALWAYS PLUG OR SEAL UNUSED HOLES IN FLOAT
OTTERBINE BAREBO INC.
Page 6
75-0009 Rev 01 50Hz Fractional Series
www.otterbine.com
1-800-AER8TER
