Otterbine Barebo Inc.
4
75-0109 AirFlo 3
www.otterbine.com
1-800-AER8TER
TUBING CONNECTIONS
A. Trenching
1. Determine the location where the air tubing will enter the water and dig a trench back to the compressor cabinet deep
enough to bury the Poly Unweighted Tubing.
B. Tubing Connections
1. Measure the distance between the compressor cabinet and the water’s edge, prepare a length of Poly Unweighted
Tubing for each diffuser manifold provided.
2. Use the couplings and clamps provided in PN: 12-0019 to couple each length of poly tubing to the heater hose
protruding from the rear of the compressor cabinet as shown.
3. Determine the distance between each Diffuser Manifold Base (PN: 10-0301 or PN: 10-0302) location and where the
Unweighted Poly Tubing ends. Prepare a length of the Weighted Tubing for each Diffuser Manifold.
4. Use couplings and clamps provided to connect the Weighted Tubing to the Poly Unweighted Tubing as shown below.
5. Using the hose clamps provided to fasten each Diffuser Manifold Base to the Weighted Tubing as shown.
AIRFLO 3 SYSTEM OVERVIEW
