Corner Pilot Hole
for Strap
1" Screw
for Handle
Mattress
Bed Base
Straps
Instructions for fixing the green strap kit
The strap kit comprises of two long lengths of green webbing with closed loops, plus two
short lengths of webbing that also have chrome metal brackets at end.
Take a long strap and slot the looped end through one of the slots on the board (as
illustrated) and then feed the coil through the loop and pull tight to secure. Repeat for the
other side.
Take a short green strap and insert one of the two small screws (supplied) through the eyelet
of the chromed metal bracket and screw home into one of the two small pilot holes near the
corners of the inner rear face of the hardwood block. Screw in until the bracket is firm against
the block with the strap hanging vertically down. Repeat for other side.
Put the device on the bed as shown in illustration and then place the webbing flat across the
bed base and pass down and under the base until it meets the short straps on other side.
Click the male and female buckles together, and adjust so that the straps are taut. Tuck any
surplus webbing under the bed.
See the diagram for a guide to the positioning of the device on the bed. This will vary slightly
depending on the client’s height and arm length.
Bed Leaver
®
Bed Rail dimensions:
Product Code:
BEDL200
(inc. straps)
BEDL250
(without straps)
Max User Weight:
108kg (17 st)
Width:
330 mm (13")
Length:
600 mm (23
1/2
")
Handle Height:
500 mm (19
1/2
")
