Amplitude
®
T-Series
- Installation Guide
12
STEP 4: CONNECT THE TRANSDUCERS
Check the alignment of the plug, and then insert the headphone transducer cable plug into the AC (Air
Conduction) port on your device.
The mini-DIN plugs used are intended to provide a very secure and tight coupling to the device so that the
optimal connection is made and if the device is dropped, the cable will remain connected. To insert the plug,
align the small pill shaped indentation in the metal collar of the plug with the bottom of the port (at 6 o’clock)
on the device and carefully push it in, but do not force the connector. If needed, wiggle the plug slightly while
pushing in.
If you intend to perform bone conduction testing and purchased an Amplitude model with the B-71 bone
conductor, check the alignment and plug that connector into the device in the BC (Bone Conduction) port.
Important Note:
The transducers must be plugged into the correct port on
the device or the test results will be inaccurate and therefore invalid.
Attaching the transducers
STEP 5: INSTALLING THE BLUETOOTH ADAPTER
Insert the Bluetooth Adapter
Before continuing with the next step, you must add the Bluetooth USB adapter to your PC. To do this, locate
an available USB port on your PC and plug the adapter into the port. Always plug the Bluetooth adapter into the
same USB port on your PC. Windows will automatically detect the adapter and configure the Bluetooth
interface. This may take 20-30 seconds to complete and at the conclusion, a balloon message will be shown in
the lower right corner of your screen indicating that the installation was successful and your adapter is ready to
use.
