No. P30051
―47―
10. OPERATION (continued)
10.4 Applied Settings
10.4.1 Using Internal Function
•
How To Use Internal Functions
Ԙ
When holding down the F key [12] for a few seconds, the function number in
the left-side display blinks, and the status of function assigned to the function
number lights up and is displayed in the right-side display. Under this
condition, a function number can be preset by using the parameter adjusting
knob [6].
The number of function blinks.
The conditions of function lights.
↓
A function number can be preset with the parameter adjusting knob [6]
The above example indicates that F19 is set to “on”.
When pressing the F key [12] again after presetting the desired function
number, the function number lights and the function conditions blinks. Under
this condition, functions can be preset by using the parameter adjusting knob
[6].
The number of function lights.
The condition of function blinks.
↓
Conditions can be set while turning the parameter adjusting knob.
The above example indicates that F4 is set to “off”.
ԙ
Pressing the F key [12] again causes the function number to light up and
returns to the step. To cancel the function mode, hold down the F key [12] for
a few seconds.
NOTE: In the function mode, no confirmation of the function is carried out
when it is changed. Upon change of the setting by using the parameter
adjusting knob [6], the change becomes valid. Therefore, before changing a
function setting, carefully check to make sure that the correct function
number is selected and that the proper setting value for the function
number is set.
UGE
,1$ 0Q
WARNNING
᳧
/min
᳐
d
Hz
%
,1$ 0Q
WARNNING
᳧
/min
UGE
᳐
d
Hz
%
