www.ostermann.eu
6
5.
For each leg assembly, fasten one foot (no. 2) with four M6x14 machine screws (no. 11)
and tighten them crosswise.
6.
The table top can be pre-drilled. Therefore, check both sides of the table
top before assembling the table frame on the underside. Adjust the width of
the table frame to the table top by sliding both halves outwards. We recom-
mend allowing at least 1.3 cm of the table top to protrude over the frame
width and centring the side brackets in this position.
7.
If the table top is pre-drilled, follow step 8 before step 7. If this is not the
case, secure the position of the centre rail (no. 4) with eight M6x10 metal
threaded screws (no. 10).
8. Check that the wooden screws are not too long and do not drill through the
surface.
We recommend that you pre-drill all the holes required for fixing the table
top. Never use countersunk screws.
Check again that the table frame and table top are correctly aligned. Fasten
the table frame to the underside of the table top using seven M5x20 wooden
screws (no. 13).
Install the switch (no. 7) so that its front is flush with the front edge of the table top. The switch can be attached anywhere
along the table top, but we recommend that you place the switch at the end so that it does not hamper you when sitting. Use
two M5x16 wooden screws (no. 14) to fasten the switch to the table top.
Do not overtighten the screws in this step. Overtwisting causes damage to the components.
