BEFORE USING FOR THE FIRST TIME
Read and follow all the instructions for this section on use and care and find a place to
keep this instruction manual ready for future reference.
For your convenience, record the complete model number (located at the bottom of the
motor) and the date you received the product, together with your purchase receipt and
attach to the warranty and service information. Retain in the event that the warranty
service is required.
NOTE: The use of attachments not recommended or sold by Sunbeam Products, Inc.
may cause fire, electrical shock, injury or damage to the product.
ASSEMBLY INSTRUCTIONS (see Figure 1)
1. Attach the lower pole to the base, insert the base securing screw and tighten the
screw into the base. Make sure to align the slot on the lower pole with the rib on the
base.
2. Pull out the inner extension tube and refit/tighten the collar. CAUTION: The collar
must be fully tightened before assembling the motor section to the pedestal
stand.
3. Loosen the thumbscrew on the rear of the motor assembly. Fit the motor assembly to
the inner extension tube and tighten the thumbscrew. CAUTION: The thumbscrew
must be fully tightened before the fan is operated.
4. Remove the blade retaining nut (turning clockwise) while holding motor shaft. Remove
the guard retaining nut (turning counter-clockwise) while holding motor housing. Take
off the motor shaft sleeve protector and discard.
5. Set the rear guard in the proper position (carry handle up) on the motor assembly.
Then screw on the guard retaining nut (turning clockwise) until tight.
6. Install the blade onto the shaft of the motor assembly and screw on the blade retaining
nut (turning counter-clockwise while holding the blade) until tight.
7. Loosen, but do not remove the guard locking screw/nut from shroud. Place the shroud
on the rear guard with the guard locking screw/nut at the bottom. Assemble the front
guard into shroud so that all sides snap. Rotate the front guard until the Oster
®
logo is
upright.
8. Secure both guards firmly by fitting and tightening the guard locking screw/nut located
at the two ends of the shroud. CAUTION: Do not over-tighten.
INSTRUCTIONS FOR USE
3
00SF1600-LA813_13ESM1.indd 4
4/3/13 4:50 PM
