English-15
CONNECTIONS
Electrical Requirements
Electrical connection
WARNING
: Make sure there is a proper ground connection before using
Water connection
Drain hose connection:
Look at the rating label for the rating voltage and connect the dishwasher to the dequate nutrition. Use the required 10
amp fuse, a time delay fuse or a circuit breaker and provide a separate circuit that serves this appliance only.
Make sure that the voltage and frequency of the power match those on the nameplate. Only insert the plug into an
outlet that is properly grounded. If the outlet to which the appliance is to be connected is not suitable for the plug,
replace the instead of using adapters or similar, as they could cause overheating and burns.
Connect the cold water supply hose to a 3/4 inch threaded connector and make sure it is secure subject in its place.
If the water pipes are new or have not been used for a long period of time, leave the water running to ensure that the
water is clear and free of impurities.
If this precaution is not taken into account, there is a risk that the water inlet will be blocked and damage the appliance.
Please note that if the hose pipes supplied do not fit your tap, please contact your center Plumbing supply store where
adapters can be purchased.
Attach the drainage tube with the rear tube of the
machine. The interface is equipped with clamps and
is tightened with a screwdriver.
Secure the drainage tube with suction cups
The drainage pipe connection: place the end of the drainage pipe in a sink or a bucket.