English - 3
INSTRUCTIONS FOR USE
Before First Use
• When using the iron for the first time, test it on a piece of cloth to be sure that the
soleplate and the water reservoir are clean.
• It is possible that the iron will discharge some smoke and release some odor during its
first use. This is due to the initial heating of the materials used. This is completely
normal and will stop shortly afterwards.
FILLING WITH WATER
You must fill the reservoir with water to use the Shot of Steam and Spray Mist features
and to get steam out of your iron.
TIP:
Each iron is tested at the factory to ensure that they function correctly. The test
may leave a small, harmless amount of water within the water reservoir.
Before you fill the water reservoir, please consider the following:
• This iron was designed for use with tap water, very hard water.
Since the Anti-Calcium System is a permanent system located
inside the water reservoir. This system removes calcium from
the water and reduces calcium build-up on the soleplate.
Therefore your iron accepts tap water eliminating the need of
keeping distilled water on hand for ironing.
IMPORTANT:
When not ironing, always set the Steam Lever to
the closed position “
” and the Fabric Select Dial to the off
position “O”.
To fill the water reservoir:
1. Lift the water fill hole cover.
2. Make sure the iron is unplugged. Set the Steam Dial to closed position “
” and the
Fabric Select Dial/Buttons to off position “O”.
3. Fill water cup with water. Pour water into iron’s water reservoir. Do not fill water
reservoir beyond maximum fill level “MAX”.
WARNING:
To prevent the risk of burns, be careful when filling a hot iron with water.
Hot metal parts, hot water and steam can cause injuries.
